Customer Inquiry of Roll Former

Dear,
God to hear from you so soon. It seams that we are understanding each other. The 20 stations are not for this profile that is on the drawing attached.
What we need: Specifications
_______________________________________

1 roll former with 20 stations.
Speed:                max 20m/min.
Roller shafts:     Diameter mm 40 or 50 h7 you choose.
(Top surface grinded and hardened?)
Free tooling length: 400mm on shaft.
____________________________________________

1 parallel sheet entering device. Max width 400mm on the inlet side.
1 profile straighter on the end of the machine.
Electricity connection: 240V 50 Hz 3phase and ground.
Remember that if you have the CE confirmation on the machine make a cover over the stations. If no CE confirmation, we make it here and do the CE-confirmation.
_____________________________________

1 hydraulic Profile cutter.

With hydraulic power plant. Equipped with hydraulic accumulator for decreasing the cutting time.
Delivered with cutting knifes. 4 different widths on middle section. Please look at the attached drawings.
Electricity connection: 240V 50 Hz 3phase and ground.
________________________________________

1 Decoiler.

If you can deliver a Decoiler that is driven on a loop control up to 20 m/min and have a hydraulic expanding mandrel.
Give me a price on this.
Coil-width max 500mm, Coil inner diameter: 610mm or 508 with spacers up to 610mm. Coil capacity 3500 kp
Outside diameter on coil 1300mm max. Must be equipped with top roll stabiliser.
Decoling capacity max 20 m/min.
Electricity connection: 240V 50 Hz 3phase and ground.
________________________________________

Roller tooling for the profile that make a straight profile without the corkscrew phenomena on z-profiles. The tooling must have possibility to make the middle section wider with roll spacers made as U shapes. Please look at the attached drawings.